Hydrolux H2

The benefits at a glance:

  • H2 sensor that is insensitive to other gases
  • Audible and visual leak indication
  • No maintenance
  • Reading memory (histogram)
  • No saturation, fast recovery
  • Can be used as hand-held sensor

The use of hydrogen detectors is a tried-and-tested method that can accurately locate even the tiniest leaks in drinking water mains.
A hydrogen mixture is pumped into the pipe via a hydrant or domestic connection and then escapes at the leak, where it can be precisely detected at the surface. Hydrogen is the lightest and cheapest of all trace gases. A mixture of 5% hydrogen and 95% nitrogen is used. This environmentally friendly gas mixture is neither combustible, toxic nor corrosive.
Because it reacts so accurately and quickly, the Hydrolux H2 is ideally for precisely locating even the smallest of leaks. Audible and visual displays help the user to find leaks. The probe can be quickly and easily removed from its carrying pole in order to locate leaks in enclosed spaces.

Display 130 x 36 mm illuminated LCD
Level saving 3 / 10 / 30 min
Memory 9 readings
Power supply 10 x AA 1.5 or 10 x AA NiMH 1.2 V > 1000 mAh
Operating time 12 h (disposable batteries)
8 h (rechargeable batteries)
IP code IP 54
Operating temperature -10 °C … +50 °C
Storage temperature -10 °C … +70 °C
Dimensions/weight 215 x 95 x 110 mm / 1,2 kg(including batteries)
PAM H2
Sensor analysis bandwidth 0 to 1% H2 in air
Sensor sensitivity 1 ppm H2 in air
Reaction time < 1 sec.
Warm-up time 6 sec
Sensor service life 2 to 5 years (depending on use)
Weigh 600 g
Connection cable 120 cm
Pole length 60 cm (retracted)
90 cm (extended)